back

Waterproofing and tiling in wastewater treatment plants

Klaeranlage

Concrete surfaces in wastewater treatment plants are permanently subjected to chemcal, biological and mechanical stresses. Areas with vehicular traffic are also subjected to heavy duty stresses and as a rule fitted with wearing tiles. For this reason, there are intense demands on the waterproofing and installation systems.

Print page
Ausgleichen LEVELLING

Cement-based patching mortar, 5 – 40 mm, wall/floor

Mineral-based corrosion inhibitor and bonding agent

Water repellent, rapid hardening screed mortar with high strength

Bonding agent for bonded cement-based screeds

Abdichten WATERPROOFING

Use flexible, mineral-based vapour permeable waterproof slurries for increased demands in interior and exterior areas with ASO-Joint-Tape-2000-S in movement joints and wall/floor junctions

Verlegen TILE INSTALLATION

Deformable adhesive

Mineral-based thin-bed adhesive UNIFIX-AEK with enhanced sulphate resistance or SOLOFLEX mixed with the polymer dispersion UNIFLEX-B at a mix ratio of 6:1 by weight

Verfugen GROUTING

Cement-based, water impermeable grout with improved mechanical and chemical resistance for joint widths from 3 – 20 mm

Epoxy resin adhesive and grout with high resistance to chemicals and mechanical stresses, available as wall or floor consistency

Chemical resistant fine grain epoxy grout, two component and solvent free

Polyurethane sealant for heavy duty movement joints