back

Process water containers

Key Facts

1 Crack repair

Professionally evaluate and close cracks (see chapter on crack repair).

2 Levelling out voids

Seal voids and defects with a single application of ASOCRET-BIS-5/40 up to a maximum thickness of 40 mm. Apply “wet in wet“ over an ASOCRET-HS-Flex slurry bonding coat.

3 Evening out surfaces

Apply ASORET-BIS-1/6 to the prepared substrate at the desired thickness (up to 6 mm in one layer) and post-treat with a felt or sponge board.

4 Waterproofing wall-floor junctions

At the wall and floor transition, as well as over connecting joints, trowel or brush apply AQUAFIN-RB400 and bond the waterproof tape ASO-Joint-Tape-2000-S without voids or folds. Completely cover whilst waterproofing the main areas.

5 Waterproofing all areas

Apply a minimum of two coats of AQUAFIN-RB400 by spray, brush or trowel.