back

Installation on magnesite and xylolite screed (MA)

Magnesitestrich

Direct contact between cement-based tile adhesives and magnesite screeds leads to the destruction of the magnesite screed due to a chemical reaction. Rear moisture permeation from the substrate must be excluded using appropriate measures. Mechanically roughen the magnesite substrate, prime with the epoxy resin ASODUR-GBM and whilst the primer is still wet, broadcast to excess with 0.5 - 1.0 mm quartz sand. Tiles can be installed after waiting a further 12 – 16 hours approximately.

Print page
Grundieren PRIMING

Water emulsifying seal based on epoxy resins resistant to diluted alkalis and acids, heating oil and petrol

Ausgleichen LEVELLING

Levelling compound for floors, when using on magnesite screeds do not exceed a max thickness of 15 mm

Abdichten WATERPROOFING

Flexible, mineral-based, vapour permeable waterproof slurry for areas with increased demands in interior and exterior areas

One component flexible waterproof slurry, wall/floor

Fabric reinforced sheet style bonded waterproof membrane

Verlegen TILE INSTALLATION

Accelerated hardening flow bed flexible mortar

Flexible natural stone adhesive

Verfugen GROUTING

Rapid hardening flexible grout, 3 – 20 mm joint width

Mineral-based multi-function flexible grout for tiles, natural stone and other finishes from 1-10 mm joint widths with FAST TECHNOLOGY

Silicone sealant for movement joints

Silicone sealant for use with natural stone