back

Installation on old tiled finishes

Fliesenbelaege alt

The existing tiled finish must be sound and load bearing. Remove loose areas and repair with MGIII cement mortar. The substrate must be cleaned and all adhesion inhibiting components such as e.g. lime, grease, dirt etc must be removed. Resin repair cracks in the substrate with a reaction resin. Abrading the old tiling increases the bond of the primer or scratch coat.

Print page
Grundieren PRIMING

Rapid drying, quartz filled dispersion primer for absorbent and non-absorbent substrates

Flexible mineral-based waterproof slurry as a scratch coat

Elastic system based tile adhesive as a scratch coat

Ausgleichen LEVELLING

Lightweight, low dust flexible adhesive for thin, medium and thick bed installation techniques

Abdichten WATERPROOFING

Flexible, mineral-based, vapour permeable waterproof slurry for areas with increased demands in interior and exterior areas

One component flexible waterproof slurry, wall/floor

Fabric reinforced sheet style bonded waterproof membrane

Brush, roller or trowel applied waterproof coating for walls and floors

Verlegen TILE INSTALLATION

Lightweight, low dust flexible adhesive for thin, medium and thick bed installation techniques

Grey, highly flexible adhesive for interior and exterior use

Rapid hardening, highly slump resistant flexible adhesive for interior and exterior use

Flexible natural stone adhesive

Verfugen GROUTING

Simple to use grout, up to 6 mm joint widths

Mineral-based multi-function flexible grout for tiles, natural stone and other finishes from 1-10 mm joint widths with FAST TECHNOLOGY

Silicone sealant for movement joints

Silicone sealant for discolouration-free elastic jointing