Installation of tiles and slabs on chipboard and floorboards


Timber substrates must be clean, dry and load bearing. Chipboard must be laid bonded, screwed and glued. Faulty timber/board substrates are to be replaced, loose floor boards are to be professionally fixed (e.g. screws etc). Seal joints between boards, planks. Produce a gap between adjoining structures of min. 5 mm by inserting a self-adhesive edge insulation strip RD-SK50.

Print page
Grundieren PRIMING

Rapid drying, quartz filled dispersion primer for absorbent and non-absorbent substrates

Ausgleichen LEVELLING

Self-levelling fibre-reinforced cement-based floor levelling compound for wood substrates, min. 10 mm thickness


Flexible, mineral-based, vapour permeable waterproof slurry for areas with increased demands in interior and exterior areas

One component flexible waterproof slurry, wall/floor

Fabric reinforced sheet style bonded waterproof membrane


Accelerated hardening flow bed flexible mortar

Rapid hardening, ductile flexible adhesive S1 for interior and exterior use

Lightweight, low dust flexible adhesive for thin, medium and thick bed installation techniques

Flexible natural stone adhesive


Rapid hardening flexible grout, 3 – 20 mm joint width

Mineral-based multi-function flexible grout for tiles, natural stone and other finishes from 1-10 mm joint widths with FAST TECHNOLOGY

Silicone sealant for movement joints

Silicone sealant for discolouration-free elastic jointing