back

Waterproofing and tiling in fountains and swimming pools

Brunnen schwimmb

In order to impede the penetration of bathing water in the levelling layer and the concrete construction of swimming pools, suitable and approved waterproof systems bonded with the tiled finish are used. Before installing tiles or stone, the pool tank structure is to be tested for watertightness. The test is carried out during a 14 day constant test fill with chlorinated water up to the upper level of the pool edge detail.

Print page
Grundieren PRIMING

Solvent free universal primer, water and alkali resistant

Special epoxy based primer

Universal epoxy based primer

Ausgleichen LEVELLING

Sprayable, cement-based patching mortar, 5 – 40 mm, wall/floor

Water repellent, rapid hardening screed mortar with high strength

Abdichten WATERPROOFING

Flexible, mineral-based, vapour permeable waterproof slurry for areas with increased demands in interior and exterior areas

Trowellable, chemically resistant bonded polyurethane based waterproof membrane

Special waterproof tape for heavy duty exposure and highly demanding areas

Verlegen TILE INSTALLATION

Mineral-based, flexible thin-bed adhesive

Lightweight, low dust flexible adhesive for thin, medium and thick bed installation techniques

Highly deformable flexible adhesive for heavy duty areas

Epoxy resin-based, chemical resistant thin-bed mortar

Chemical resistant fine grain epoxy grout, two component and solvent free

Verfugen GROUTING

Cement-based, water impermeable grout with improved mechanical and chemical resistance for joint widths from 3 – 20 mm

Epoxy resin-based, chemical resistant thin-bed mortar

Chemical resistant fine grain epoxy grout, two component and solvent free

Silicone sealant for underwater areas