back

Installation of glass tiles and mosaics

Glasfliesen

Glass tiles and mosaics are translucent or transparent with a coating to the rear. Without a rear coating the adhesive is visible. Selecting a white adhesive intensifies the colour of the glass tile or mosaic. ASODUR-DESIGN can be used for the installation and grouting of translucent glass mosaics for equal colour. To achieve good adhesion to the glass, a highly modified adhesive should be used. Optimum results are achieved, as a rule with epoxy resin based adhesives, which can also serve as the grout for glass tiles and mosaics.

1) Modified with UNIFIX-F
2) Not for installation in underwater areas

Print page
Grundieren PRIMING

Solvent free universal primer, water and alkali resistant

Special epoxy resin based primer

Universal epoxy based primer

Ausgleichen LEVELLING

Non-sag, cement-based, rapid hardening, polymer modified, low shrinkage and creamy smoothing compound, 2 – 50 mm

Smoothing compound from 2 – 30 mm

Water repellent, rapid hardening screed mortar with high strength

Abdichten WATERPROOFING

Flexible, mineral-based, vapour permeable waterproof slurry for areas with increased demands in interior and exterior areas

Trowellable, chemically resistant bonded polyurethane based waterproof membrane

Verlegen TILE INSTALLATION

White flexible adhesive for installation in thin-bed techniques 1)

White, rapid hardening flexible adhesive for installation in thin-bed techniques 2)

Chemical resistant fine grain epoxy grout, two component and solvent free

Verfugen GROUTING

Mineral-based multi-function flexible grout for tiles, natural stone and other finishes from 1-10 mm joint widths with FAST TECHNOLOGY

Chemical resistant fine grain epoxy grout, two component and solvent free

Silicone sealant for movement joints