back

Waterproofing and tiling in brine pools

Soleschwimmbecken

In addition to pools, which are filled with bathing water of drinking water quality to DIN 19 643, brine pools and their surrounds are subjected to chemical exposure from minerals and salts. The waterproofing and installation systems used in these areas must be resistant to these. As a rule, the concrete construction as well as the mineral-based levelling layers are protected against water aggressive to concrete, by these waterproofing and installation systems.

The optional use of a conductive strip and conductive lacquer between primer and the waterproofing membrane gives the possibility of a non destructive test for watertightness of the membrane using a spark coil test to DIN 55670 under high voltage. The time consuming and costly test via a 14 day trial fill of the pool with water can be dispensed with.

Print page
Grundieren PRIMING

Special epoxy resin based primer for damp substrates and as protection against moisture penetration from the rear

Universal epoxy based primer

Ausgleichen LEVELLING

Sprayable, cement-based patching mortar, 5 – 40 mm, wall/floor

Water repellent, rapid hardening screed mortar with high strength

Abdichten WATERPROOFING

Self adhesive copper conductive strip (for conductive control, optional)

Aqueous epoxy resin based conductive lacquer (for conductive control, optional)

Special waterproof tape for heavy duty exposure and highly demanding areas

Trowellable, chemically resistant bonded polyurethane based waterproof membrane

Verlegen TILE INSTALLATION

Epoxy resin-based, chemical resistant thin-bed mortar

Chemical resistant fine grain epoxy grout, two component and solvent free

Verfugen GROUTING

Epoxy resin-based, chemical resistant grout

Chemical resistant fine grain epoxy grout, two component and solvent free

Silicone sealant for underwater areas