back

Installation on heated and unheated cement-based screed (CT)

Zementestrich%20%28ct%29

Firstly carry out a moisture test. The CM moisture content may not exceed 2.0 CM% for floating or unbonded screeds. Heated screeds must be commissioned beforehand. With bonded CT screeds, moisture measurements are not necessary.

Print page
Grundieren PRIMING

Solvent free universal primer, water and alkali resistant

Ausgleichen LEVELLING

Smoothing compound from 2 – 30 mm, interior and exterior areas

Entkoppeln DE-COUPLING/INSULATION

Thermally insulating impact sound deadening and de-coupling board, 4/9/15 mm

Abdichten WATERPROOFING

One component flexible waterproof slurry, wall/floor

PU waterproof membrane for heavy duty water exposure and limited chemical exposure

Fabric reinforced sheet style bonded waterproof membrane

Flexible, mineral-based, vapour permeable waterproof slurry for areas with increased demands in interior and exterior areas

Verlegen TILE INSTALLATION

Hard wearing epoxy resin, two component and solvent free

Grey, highly flexible adhesive for interior and exterior use

Flexible natural stone adhesive

Creamy consistency flexible adhesive

Verfugen GROUTING

Mineral-based multi-function flexible grout for tiles, natural stone and other finishes from 1-10 mm joint widths with FAST TECHNOLOGY

Chemical resistant fine grain epoxy grout, two component and solvent free

Hard wearing epoxy resin, two component and solvent free

Silicone sealant for use with natural stone

Rapid hardening flexible grout, 3 – 20 mm joint width

Silicone sealant for movement joints