Installation of porcelain tiles

Porcelain stoneware tiles are designated as tiles with water absorption of ≤ 0.5%. This concerns a fully vitrified laying material with an extremely high density. To install porcelain stoneware tiles, polymer modified bedding mortars are needed in order to produce optimum bonding to the very dense surface of the tile. Grouts with accelerated binding are particularly suitable for the grouting of porcelain stoneware tiles.

Print page

Solvent free universal primer, water and alkali resistant


Non-sag, cement-based, rapid hardening, polymer modified, low shrinkage and creamy smoothing compound, 2 – 50 mm

Self-levelling, cement-based smoothing compound from 2 – 30 mm


Thermally insulating impact sound deadening and de-coupling board, 4/9/15 mm


One component flexible waterproof slurry, wall/floor

Flexible, mineral-based, vapour permeable waterproof slurry for areas with increased demands in interior and exterior areas


Rapid hardening, ductile flexible adhesive S1

Lightweight, low dust flexible adhesive for thin, medium and thick bed installation techniques

Grey, highly flexible adhesive for interior and exterior use


Rapid hardening flexible grout, 3 – 20 mm joint width

Mineral-based multi-function flexible grout for tiles, natural stone and other finishes from 1-10 mm joint widths with FAST TECHNOLOGY

Silicone sealant for movement joints